How-To Guide
How to Season a Humidor, Step by Step
To season a humidor, raise the moisture in its Spanish cedar slowly — with distilled water or seasoning packs — until it holds a steady 65–72% humidity before you add cigars.
Updated · Men Cigar Accessories Editorial Team
Compare Humidor Types →
Learning how to season a humidor is the most important step with any new wooden humidor. Kiln-dried cedar is thirsty. Put cigars into an unseasoned humidor and the wood will pull moisture out of them. Seasoning saturates the cedar first so it becomes a moisture reservoir instead.
What You Need
- Distilled water (never tap water, which leaves minerals and can encourage mold)
- A clean, lint-free cloth or new sponge
- A small dish, or high-humidity seasoning packs
- A hygrometer, ideally digital
- Your humidifier or two-way humidity packs for after seasoning
Step-by-Step Seasoning
- Calibrate the hygrometer first (see below) so you can trust the readings.
- Lightly wipe the cedar. Dampen a cloth with distilled water, wring it out well and wipe the interior cedar surfaces. The wood should be damp, not wet — no pooling water.
- Add a moisture source. Place a small dish of distilled water, or seasoning packs, inside, along with your charged humidifier.
- Close the lid and wait. Leave it closed for several days, checking once a day. Seasoning commonly takes a few days to two weeks.
- Watch for stability. When the hygrometer holds steady in the target range for a day or two after you remove the dish, the humidor is seasoned.
- Add cigars gradually. Add them over a few days if you're filling a large humidor, and switch to your normal humidity packs or humidifier.
Quick answer: Wipe the cedar lightly with distilled water, place a dish of distilled water or seasoning packs inside, close the lid and wait several days to two weeks, until the hygrometer holds steady at about 65–72%.
What Humidity Should a Humidor Be?
| Humidity | Effect on cigars |
|---|---|
| Below 60% | Cigars dry out; burn hot and fast; wrappers can crack |
| 62–65% | Preferred by some for a sharper burn and denser cigars |
| 65–70% | The most common target for premium cigars |
| 70–72% | The traditional standard; slightly softer cigars |
| Above 75% | Poor draw, burn problems and growing risk of mold |
Temperature matters too. Aim for about 65–70°F. Sustained temperatures above roughly 75°F raise the risk of tobacco beetles hatching.
How to Calibrate a Hygrometer (Salt Test)
Hygrometers drift, so test yours before you rely on it. The classic salt test works because a damp salt slurry holds the air around it at about 75% relative humidity.
- Put a capful of table salt in a bottle cap and add a few drops of water so it becomes damp, not dissolved.
- Place the cap and the hygrometer in a sealed zip-top bag.
- Wait at least 6–12 hours, away from temperature swings.
- The hygrometer should read 75%. If it reads 72%, it reads 3 points low — adjust it or remember the offset.
Ready-made calibration kits that hold a known humidity are also available if you prefer not to mix your own.
Common Seasoning Mistakes
- Using tap water. Minerals clog humidifiers and can feed mold. Use distilled water.
- Soaking the wood. Puddles can warp cedar and lift the lining. Damp, not wet.
- Rushing. Adding cigars before the reading is stable lets the cedar draw moisture from them.
- Trusting an uncalibrated hygrometer. Analog dials can be off by 10 points or more.
Maintaining Humidity Afterward
Two-way humidity packs are the simplest way to maintain a seasoned humidor: they add or absorb moisture to hold a set level and need no mixing. Replace them when they become stiff. Traditional humidifiers should be refilled with distilled water or a propylene glycol solution, as their maker directs. Learn more about choosing a box in our cigar humidor guide.
Frequently Asked Questions
How do you season a humidor?
Lightly wipe the cedar with distilled water, place a dish of distilled water or seasoning packs inside, close the lid and wait until the hygrometer holds steady at about 65 to 72 percent.
How long does it take to season a humidor?
Seasoning usually takes from a few days to about two weeks, depending on the humidor's size and how dry the cedar was.
What humidity should a humidor be?
Most smokers keep humidors at about 65 to 70 percent relative humidity; 70 to 72 percent is the traditional standard.
Can I use tap water to season a humidor?
No. Use distilled water, because tap water leaves minerals that clog humidifiers and can encourage mold.
How do I calibrate a hygrometer?
Seal the hygrometer in a bag with a cap of damp table salt for at least 6 to 12 hours; it should read 75 percent, and any difference is its offset.


